EOS Utility

Discussion in 'Technical Troubleshooting' started by Beermat, Mar 15, 2022.

  1. Beermat

    Beermat New Member

    Joined:
    Mar 15, 2022
    Messages:
    5
    Hi,

    I'm using the EOS utility on Windows 10 and when I switch on the camera the app automatically launches.

    Normally, I make some settings changes to the camera and I am ready to go so I close down the app. However, if I want to make subsequent changes and launch the app again it will not connect to the camera this time. I have to power off/on the camera for the app to connect again or disconnect/connect the USB cable.

    Is there an option to launch the app and connect to the camera at any time or multiple times?

    Thanks,
     
    Beermat, Mar 15, 2022
    #1

  2. Craig Sherriff

    Craig Sherriff Well-Known Member Site Supporter

    Joined:
    Apr 25, 2017
    Messages:
    3,223
    Location:
    Tasmania, Australia
    Equipment:
    60D,350D 1dmark3, T70, AV1, lenses ranging from 28mm to 600 mm, canonet Junior, Canonet QL 25, Mamiya C3 and 3 lens sets,Mamiya 645 pro TL and 3 lenses.Mamiya universal press camera and 4 lenses, Mamiya RB67 Pro S and 5 lenses, Pentax MG and various lenses, Toyoview 4 * 5 inch large format camera,Calimat C1 8*10 inch ultra large format camera.
    Welcome Beermat, this is one of the multiply issues with windows 10, this version of windows sucks. I purchased windows 7 and have not had any issues, but this does not fix your problem. Welcome anyway.
     
    Craig Sherriff, Mar 15, 2022
    #2
  3. Beermat

    Beermat New Member

    Joined:
    Mar 15, 2022
    Messages:
    5
    Thank you
     
    Beermat, Mar 16, 2022
    #3

Share This Page